Wednesday, December 4, 2019

Building Code free essay sample

The provisions of this Code shall apply to the design, location, siting, construction, alteration, repair, conversion, use, occupancy, maintenance, moving, and demolition of, and addition to, public and private buildings and structures. (b) Additions, alterations, repairs, and changes of use or occupancy in all buildings and structures shall comply with requirements for new buildings and structures except as otherwise herein provided. Only such portion or ortions of the existing building or structure which have to be altered to effect the addition, alteration, or repair shall be made to conform to the requirements for new buildings or structures. Alterations should preserve the aesthetic value of the building to be altered. (c) Where, in any specific case, different section of this Code specify different materials, methods of construction, or other requirements, the most restrictive shall govern. All devices or safeguards, which are required by this Code in a building or structure when constructed, altered, or repaired, shall be maintained on good working order. We will write a custom essay sample on Building Code or any similar topic specifically for you Do Not WasteYour Time HIRE WRITER Only 13.90 / page SECTION 1. 01. 07: Insanitary, Unsafe, Hazardous, or Dangerous Sites (a) The land or site upon which will be constructed any building or structure, or any ancillary or auxiliary facility thereto, shall be sanitary, hygienic or safe. Where the land or site is polluted, insanitary, unhygienic, unsafe, or hazardous, conditions contributing to or causing its being polluted, insanitary, unhygienic, unsafe, or hazardous shall be reasonably improved or corrected, or proper remedial measures shall be prescribed or incorporated in the design or construction of the building or structure in accordance with the provisions of this Code. b) The land or site upon which be constructed a building of structure or any ancillary or accessory facility thereto, for use of human habitation or abode, shall be at a safe distance from streamers or bodies of water and/source of air considered to be polluted, volcano or volcanic site, and building or structure considered to be a potential source of fire or explosion, such as ammunitions factory or dump and storage place for highly inflammable material. SECTION 1. 01. 08: Dangerous and Ruinous Buildings or Structures (a) General. The provisions of this Code shall apply to all dangerous buildings, as herein defined, which are now in existence or which may hereafter be constructed, as well as to ruinous buildings as defined in Article 482 of the Civil Code of the Philippines. (b) Dangerous Buildings Defined. Dangerous buildings are those which are structurally unsafe or not provided with safe degrees, or which constitute a fire hazard, or are otherwise dangerous to human life, or which in relation to existing use constitute a hazard to safety or health or public welfare, by reason of inadequate maintenance, dilapidation, obsolescence, fire hazard, or abandonment; or which otherwise contribute to the pollution of the site or the community to an intolerable degree. Any building or structure which has any or all of the conditions or defects hereinafter described, or conditions or defects similar thereto, shall be deemed to be dangerous building: Provided, That such conditions or defect exists to the extent that the life, health, property, or safety of the public or its occupant are endangered: (1) Whenever any door, aisle, passageway, stairway, or other means of exist is not of sufficient width or size, or is not so arranged as to provide safe and adequate means of exit in case of fire or panic; 2) Whenever the stress in any materials member or portion thereof, due to all dead and live loads is more than one and one-half times the working stresses or stresses allowed in this Code for new building of similar structure, purpose, or location: Provided, That in determining working stress, the working stress method of analysis shall be used, and in the case of engineering overstress, the ultimate strength method; 3)